MA6000
Ny produkt
Professional Power Amplifier 2x3000W - 2ohm
Varning: Sista varan i lager!
Tillgänglig efter datum:
MA6000
Professional Power Amplifier 2x3000W - 2ohm
Mottagare: :
* Obligatoriska fält
eller Avbryt
KEY FEATURES
Calibrated input attenuators
Signal present, Maximum power and Protection
XLR and 6,35mm TRS jack paralleled balanced inputs
Mode selector (Parallel, Stereo or Bridge)
Anti-clipping compressor and Earth-lift switches
MAIN CHARACTERISTICS
Stereo 8ohm: 2x 1400W
Bridge 4ohm: 6000W
Frequency Response (half power): 15Hz - 25Hz (+0 / -1dB
Damping Factor 1kHz at 8ohm: >400:1
Input Impedance: 10kohm balanced to ground
The supply
The MA series power supply uses high-current toroidal transformers and a huge capacitor bank to ensure an uncommonly high amount of stored energy. This makes a critical difference in sound quality allowing incredible transient response and speakers motion control, even when driving 2 ohm loads.
The audio performance
To achieve its remarkable sound quality, the NEXT MA series output circuits were engineered as a high bandwidth, very low bias and feedback class AB or H (MA3200 andMA3800), using the highest grade linear output devices. This approach yields outstanding studio-quality sound accuracy and detail.
Output Power (RMS)
Stereo 8Ω: 2x 1400W
Stereo 4Ω: 2x 2100W
Stereo 2Ω: 2x 3000W
Bridge 8Ω: 4200W
Bridge 4Ω: 6000W
Inputs and Outputs
Input Sensitivity: Selectable (0.77V / 1.0V / 1.44V)
Input Impedance: 10kΩ balanced to ground
Input Connectors: Female & Male XLR-3
Output Connectors: 4 pole Speakon and binding posts
Audio Performance
Frequency Response (half power): 15Hz - 25.000Hz (+0 / -1dB)
THD+N at 1kHz (half power): <0.025%
IMD 60Hz and 7kHz, 4:1: <0.04%
Signal to Noise Ratio: >105dB
Slew Rate (Input Filter Limited): 40V/uS
Damping Factor 1kHz at 8Ω: >400:1
Features
Amplifier Topology: Class H
Protections: Full short circuit, open circuit, thermal, soft start, DC, Sub/Ultrasonic and RF
LED Indicators (Per Channel): Active, signal, limit, protect
Panel Controls: Front: 2 input attenuators | Rear: Ground lift, mode selection, compressor
Cooling: Front to back via 2 variable speed fans
General
Power Requirements: 230VAC, 50Hz-60Hz (others by request)
Dimensions (WxDxH): 482mm x 468mm x 132mm (18.98 x 18.43 x 5.2in)
Net Weight: 37.2kg (82lb)
Shipping Weight: 39kg (86lb)